MakerWorld
Hand Tools
Go to Model
SpreaderNotched
105
Downloads
3
Likes
79
Makes
Glue / Filler / Silicone spreader. I printed this as i needed to run some filler/silcone seamsealer over some weld on the van and tigerseal type stuff is very messy even with gloves on. So i created these little 70mm x 25mm or 1x2.5 inch spreaders which take less than 15 mins to print and cost around 3p so they can be thrown away instead of cleaning them. I printed the ones in the picture in (tecbear) PETG on an X1c with gold textured pei plate using generic PETG settings and they worked brilliantly. I can't upload the little vid i made which is shame to show you how flexible these are. I put two on the plate, one has a 5mm diameter pair of notches and the other has 4mm, the print time is only 8mins for both.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
