MakerWorld
Hand Tools
Ver Modelo
SpreaderNotched
105
Descargas
3
Likes
79
Makes
Glue / Filler / Silicone spreader. I printed this as i needed to run some filler/silcone seamsealer over some weld on the van and tigerseal type stuff is very messy even with gloves on. So i created these little 70mm x 25mm or 1x2.5 inch spreaders which take less than 15 mins to print and cost around 3p so they can be thrown away instead of cleaning them. I printed the ones in the picture in (tecbear) PETG on an X1c with gold textured pei plate using generic PETG settings and they worked brilliantly. I can't upload the little vid i made which is shame to show you how flexible these are. I put two on the plate, one has a 5mm diameter pair of notches and the other has 4mm, the print time is only 8mins for both.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
