Spring loaded Bed level KOSSEL

After a lot of try to level bed on Anycubic Kossel accurately i finally made a solution to this problem. Since stock holders can't adjust in height i always had one side lower than another, even probing did't help for some reason.

#_#_#_#_#_#_#_#_#_#_#_#_#_#_#_#_#
DESIGNED FOR 3mm bed + 3mm Glass
#_#_#_#_#_#_#_#_#_#_#_#_#_#_#_#_#

This thing can help you with that. I made perfect level with it. It can be used with heated bed (just don't heat it too much) perfect for PLA 60C.

To make one you will need
- 3x30 bolt x1
- 9,5x19 spring x1
- 3x20 bolt x2
- M3 nut x4
- printed parts

PRINTING!!!
Notice that bottom part should contain a nut inside. To make this, setup your slicer to pause at level that will close nut compartment and insert a nut inside, than resume printing.

After printing drill central hole with 3.5 drill bit.