Thingiverse
Spring Thunder composite grip
von ehdrien
20
Downloads
24
Likes
0
Makes
This is a grip for the Gdop26 Spring Thunder that is inspired by the Orion Blasters Lynx's grip.
It requires no support material to print. As a bonus, the rear of the grip can be printed in TPU for some padding.
Print the frontstrap laying down on it's back. Print the backstrap standing up on it's base. Make sure to use any "lay flat" feature of your slicer to ensure the parts are flat onto your bed!
Assemble with two 1 1/2" 6-32 screws.
It requires no support material to print. As a bonus, the rear of the grip can be printed in TPU for some padding.
Print the frontstrap laying down on it's back. Print the backstrap standing up on it's base. Make sure to use any "lay flat" feature of your slicer to ensure the parts are flat onto your bed!
Assemble with two 1 1/2" 6-32 screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
