Springy Bunny

Small Bunny with springy body Version 1.1 17 V 2026 Can be printed in parts (body + eyes) Optional keyring or space for 5x5mm magnet Additional files for a multicolor print --- If you want to sell prints of this model you can buy a commercial license Check my bio for a LinkTree --- Video https://www.instagram.com/reel/DYcZ9QXNSdL/ --- Print settings 0.1-0.2mm layer height 7% gyroid infill 2-3 walls May be harder to print than typical models You will need a good bed adhesion and a good cooling You may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a thin knife (scalpel) It mostly depends on your seam settings and filament stringing If you will have problems with a nozzle knocking out spring parts you can use ADDON_Spring-joiner wich will connect spring parts on the bottom with two lines - you will need to cut it with a knife after a print ADDONs should be merged with base model (except ADDON_Magnet) If you want a magnet inside add a 'negative volume' and select ADDON_Magnet_5x5mm or add a cylinder with proper size (0.1-0.2mm bigger diameter than a magnet and 0.2-0.4mm highier) Also you will need to add a pause - usually on the first layer where the magnet hole is closing --- MULTICOLOR Select a base model and all of MULTI files, then drop them in slicer, merge together and select color for each part Multicolor files are with a 'frame' that helps with models aligning DO NOT try to 'repair' the models - frame will not be printed and it's not causing any problems with slicing Colors Body - creame Light - white Black - black or dark brown Pink - light, desaturated pink --- Tips if the model is breaking Filament should be dry and with good self adhesion Printing with wet filament will make the model more brittle (especially PLA) and model may break when stretched Silk filaments (especially dual or tripple color) and the ones with particles (like 'marble') may not be a good option - but it