Thingiverse
springy giftbox
von Sagittarius0
5
Downloads
6
Likes
0
Makes
A gift box which, when pulled, can extend quite far. It can be a fun toy but it has thin walls, so it is not that strong.
Printsettings
Was printed ad 0.2 mm layer height.
Does need support, but the spring should be printed without support, so add a support blocker in the middle of the print (going from the bottom to the top) as shown in the figure.
Printsettings
Was printed ad 0.2 mm layer height.
Does need support, but the spring should be printed without support, so add a support blocker in the middle of the print (going from the bottom to the top) as shown in the figure.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
