Thingiverse
Sprouting jar lid
door Ciabolo
160
Downloads
141
Likes
6
Makes
This is a lid to screw on an empty jar to make a sprouting jar. I used an empty pickles jar.
The filament I used was PETG
I designed two versions of the lid. One with bigger holes an one with smaller holes. The version with the bigger holes prints a bit better but some very small seeds may fall through the holes.
The filament I used was PETG
I designed two versions of the lid. One with bigger holes an one with smaller holes. The version with the bigger holes prints a bit better but some very small seeds may fall through the holes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
