Squared Glider

This is another well designed glider. Its a little heavier and sturdier than a couple of my previous models, but it still launches and throws very well. All it requires is a nut that's roughly 11mm in diameter that's placed in the head of the glider, the plug then goes in the top of the cavity. No glue required the plug has a very tight fit. You may need to insert it then press it against a flat surface to get it flush. No supportsNo glueGlider prints one piece (beside a small plug)Weighted and sturdy Check out my other gliders.https://makerworld.com/en/models/1003139-falcon-gliderhttps://makerworld.com/en/models/1003123-viper-glider-the-best-glider-you-ll-find#profileId-1148678https://makerworld.com/en/models/1633328-screw-balanced-glider-flies-extremely-well