SSX-23 Single Stack Mod

I created this because I bought a Tapp m4 adapter and it had some pretty serious feeding issues because the tolerances on the single stack mod were too tight.

The higher the number in the prefix means that more material was removed. (The higher the number the better it fed for me.)

You may have to sand a little bit to make sure that it fits the way that you expect.

I tested this with a TM MK23 mag.

I printed this on an ender 3 with no supports.

You will need to scale this up (I designed it using inches instead of mm) I included an image of my scaling settings. Y-Axis is roughly 114.3mm and you should be good.