Stackable Ball Garage

At long last, by popular demand, I present a stack-able ball garage for the Golf Ball Dispenser Pro! I designed this to be compatible with the original garage and funnel. There are two versions, one that has about the same footprint as the original garage, and one that is a bit larger to complement the giant garage bringing total balls stacked to be around one hundred. Reinforcing spine included. These should be stack-able to an unlimited height however I have not tested stacking more than one. Due to clearances where the giant garage meshes with the ball tower, the whole setup gets kinda wobbly at the height in the photo, but not so wobbly that it is at risk of tipping over. I've dumped about thirty or so balls in at once and it went fine. Print in the same orientation as the original garage, flat back down, no support required. As with all of my designs on this product, there is plenty of clearance for PETG prints. If any of you mad lads print a bunch of these and stack them then