Thingiverse
Stackable Box V4 - 27cm long version 1L
von Anonaab
0
Downloads
0
Likes
0
Makes
I designed this to be printed vertically on a delta printer with minimal supports. Added interior notches to hold 3mm separator wall plates.
Calculated interior volume to be about 1 liter. Requires 115g of material and costs ~2 euros. I didn't print this because I found injection molded boxes for cheaper at a supermarket.
Calculated interior volume to be about 1 liter. Requires 115g of material and costs ~2 euros. I didn't print this because I found injection molded boxes for cheaper at a supermarket.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
