Stackable Egg Holder - One part version - NEW

It is able to hold eggs ranging from S all the way up to XL. Each part can hold 10 eggs.I made this with Fusion360 after beeing inspired by reading tfhh's comment on the old version.This remix makes cycling through your “best use by” dates way easier as it is stackable with itself without using a base part. If you only need 10 eggs, go here and only print the lower part.Counter point would be, the whole stack might be a bit higher than using the old version.----------------------------------------------------------------------------------------------------------------If you want to help me out a bit and see some stuff I made, work in progress, or models before they will be here consider liking and following my Facebook page, thank you very much - it means a lot to me! :)---------------------------------------------------------------------------------------------------------------- Print with:PLA3 wall loops and top / bottom shell layers15% infillNo supports are neededBrim is needed for