Thingiverse
Stackable filament storage
door lewis_jeffery
1
Downloads
4
Likes
0
Makes
A design for a tight sealing filament case, capable of being stacked is provided.
The bottom container neatly fits a 1kg spool of 200mm dia x 65mm. The lid screws down onto a soft TPU gasket to provide a tight seal.
This design is intended for storage of the more water sensitive materials such as nylon that, in my case, are not used frequently. I doubt the effort and expense of this container is warranted for basic materials that are consumed quickly.
An extension piece that allows additional spools to be stored is included although I tend not to use this much. I prefer dedicated single containers.
PLA is slightly permeable to humidity in the air. A few silica gel bags can be stored inside the spool to keep this under control.
The bottom container neatly fits a 1kg spool of 200mm dia x 65mm. The lid screws down onto a soft TPU gasket to provide a tight seal.
This design is intended for storage of the more water sensitive materials such as nylon that, in my case, are not used frequently. I doubt the effort and expense of this container is warranted for basic materials that are consumed quickly.
An extension piece that allows additional spools to be stored is included although I tend not to use this much. I prefer dedicated single containers.
PLA is slightly permeable to humidity in the air. A few silica gel bags can be stored inside the spool to keep this under control.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!