Thingiverse
stackable flying riser base for ttrpg miniatures (1" base)
von AlienBard
118
Downloads
66
Likes
0
Makes
This is a riser for holding flying characters above the game board. The upper piece will be held about 2 inches high which equals 10 feet in most common rpg games.
The bottom disk is about 1 inch diameter so will allow pieces to rest under it. The upper disk is a little bigger and has an inset to hold a second riser (or more if you are feeling brave - I don't know how stable it would be without a weighted base) or the flying piece if it has a standard size base.
This should be printable at 90 degrees with minimal supports needed on either resin of fdm printers.
The bottom disk is about 1 inch diameter so will allow pieces to rest under it. The upper disk is a little bigger and has an inset to hold a second riser (or more if you are feeling brave - I don't know how stable it would be without a weighted base) or the flying piece if it has a standard size base.
This should be printable at 90 degrees with minimal supports needed on either resin of fdm printers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
