Slicer Discord
Stackable HDD & SSD Storage Boxes – 3D-Druckmodell von Cults3D Cults3D € Paid
Gadget

Stackable HDD & SSD Storage Boxes

von MrKrueger · Gadget
1 Downloads
0 Likes
0 Makes
Zum Modell
Stackable storage boxes for 2,5inch and 3,5inch harddrives and SSD's.

These boxes have a groove on the bottom that locks into the top of another of these boxes.
Drives go in sideways to increase the bottom surface area so they are more stable and can stack higher.
The tops of the drive slots have finger cutouts to more easily take drives from the box.

The 2.5inch drive version takes 26 drives up to 9.5mm thick, which is the most common maximum thickness for these drives. SSD's are usually only 7mm thick and thus will also fit.

The 3.5inch drive version takes 10 drives up to 26.11mm thick, which is again the most common maximum thickness for this type of drive. This should fit thick bois like the Exos X16 (this one's for you, Datahoarder crowd!)
Kategorie
Gadget
Quelle
Cults3D
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

MrKrueger veröffentlicht auch auf

42 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen