Stackable Jewelry Box

Everyone has a bit of jewelry. Some have a little. Some have more. Some have a lot. But some have more than a lot. So I made a stackable jewelry box with a locking latch to keep your piles of gold organized and safe. - Printing Notes -You will need 3 mm by 6 mm magnets. Each box uses 4 magnets, so 2 boxes need 8. When printing the top box, the magnets in the box will need to oppose the ones in the lid. So if the north side of the magnets in the box are facing up, then the north side of those in the lid will be facing down. That way, when you press the buttons, the latches will release and the magnets will push against each other. When printing the STAX drawers, the magnets will be attracting each other. This way, a lock mechanism is not needed. The springs will lose power over time so I recommend printing them and the latches in PETG. - Assembly Instructions - Squeeze the locking latch into the box. If the fit is too tight, gently pull on the wall of the box. Grab two springs, orient t