Stackable storage box for miniatures

A storage box with movable separators, made for table top miniatures but could be used for anything. The lid is put on the box by sliding into two guides and is held in place by them. The feet on top of the lid fit on the bottom of another printed box so if you stack them they won't slide off easily. Inside the box there are 6 slots to put separators into to subdivide the spice however you want. Total box size is 250x220x110. WARNING: I printed this with SUNLU PLA+ 1.0, the bed adhesion was perfect but due to the size of the box the entire magnetic plate bent! Make sure to prepare the print in the best way it suits you to reduce warping ( i fixed it mid print with some duct tape) WARNING 2: Despite the splicer not giving a warning when printing the brim in a P1S the head cover might collide with the wire cutter levver and be knocked off. When the brim is done this collision won't happen again. I suggest you find a way to keep the lever out of the way or let it collide, fix the