Thingiverse
StackAbles
door DanBuro
12
Downloads
9
Likes
0
Makes
This is an answer to a question posted in the forum
Here: https://www.thingiverse.com/groups/engineering/forums/general/topic:22405
"Inexpensive 3D Printed Stackable blocks to build a Playhouse. Taking the LEGO type block and scaling up is to costly in material and time to print. Is there a better way?"
Since this design is a open ended box material and time is reduced by a lot
You can fill these with expanding foam to make them even stronger.
I'm not done with variations yet but it gets to the point
There is 20cm x 10cm x 10cm Block, Base and Cap
There is 10cm x 10cm x 10cm Block, Base and Cap
There is 20cm x 10cm x 10cm 90deg Arc Block, Base and Cap
I'm uploading a 45deg pitch block then I'll get to Windows, Doors and Flats.
Here: https://www.thingiverse.com/groups/engineering/forums/general/topic:22405
"Inexpensive 3D Printed Stackable blocks to build a Playhouse. Taking the LEGO type block and scaling up is to costly in material and time to print. Is there a better way?"
Since this design is a open ended box material and time is reduced by a lot
You can fill these with expanding foam to make them even stronger.
I'm not done with variations yet but it gets to the point
There is 20cm x 10cm x 10cm Block, Base and Cap
There is 10cm x 10cm x 10cm Block, Base and Cap
There is 20cm x 10cm x 10cm 90deg Arc Block, Base and Cap
I'm uploading a 45deg pitch block then I'll get to Windows, Doors and Flats.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
