Thingiverse
Staircase Marble Machine
door Baychattan
141
Downloads
87
Likes
2
Makes
This is a re-work of Automata - Marble Machine by Sebastian Bolona, to make it more suitable for 3d printing.
It has the following parts:
- base
- top
- shaft
- nut (goes on the end of the shaft)
- cams (five of these needed - fit alternatively up and down on the shaft)
- lifts (five different ones, of increasing height)
The finished machine works best with 6.35mm ball bearings.
The parts are designed with 0.2mm clearances, but you may need to file them a bit depending on the accuracy of your printer. The design was done in Fusion 360, and the design file (as a .step) is included in case you want to adjust anything.
The cams have a hexagonal hole to thread onto the hexagonal section of the shaft, so nothing needs to be glued.
It has the following parts:
- base
- top
- shaft
- nut (goes on the end of the shaft)
- cams (five of these needed - fit alternatively up and down on the shaft)
- lifts (five different ones, of increasing height)
The finished machine works best with 6.35mm ball bearings.
The parts are designed with 0.2mm clearances, but you may need to file them a bit depending on the accuracy of your printer. The design was done in Fusion 360, and the design file (as a .step) is included in case you want to adjust anything.
The cams have a hexagonal hole to thread onto the hexagonal section of the shaft, so nothing needs to be glued.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
