Static Rocket Launch Pad

FIRST POST!

*This project is meant for Ender 3 Pro or with same size platform. You might have to scale this down by 10%.*

Static Launch Complex (SLC) is made for model rockets to be tested. For example, you could have a 3D printed rocket and use this to make sure the parachute does come out.

One more Remix Source File - https://www.thingiverse.com/thing:4667161
Many thanks to this person as there wouldn't be any water to control the temperature inside or it would melt.

This took at least more than 148 HOURS! That's a lot. This project was first started in January of 2022, but then was cancelled because I thought it would melt and found it too challenging to start from scratch but then found other people's launch pads and put those into one. This took at least two months to get done. From May 25 to July 25 is when it got done.

These pieces will need to be soldered together.

The screw and bolt are the only ones that need to be orientated.

MADE WITH TINKERCAD