Thingiverse
Steam Engine
27
Downloads
28
Likes
0
Makes
A little engine that I made, I don't have an air compressor so its running off a motor but its pumping air, I think it will run on air, I got it to turn over a few time by blowing.
Parts print with no tolerance so some sanding is required on the pistons, this is to allow them to be sanded smooth
The small Piston needs to be offset by 90 Degrees on the shaft.
Video: https://www.youtube.com/watch?v=awbFylGSkgI
Parts print with no tolerance so some sanding is required on the pistons, this is to allow them to be sanded smooth
The small Piston needs to be offset by 90 Degrees on the shaft.
Video: https://www.youtube.com/watch?v=awbFylGSkgI
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
