Thingiverse
Step-up ring extension
von Han_Ne
19
Downloads
23
Likes
0
Makes
Aim: Private use for the P900 I have access to.
I used a lathe to cut a standard 67-77mm step -up ring such that the inner part had 69mm outer diameter. Then used this thing to elongate the step-up ring along the lens axis. Glue the part onto it.
Why:
a) The P900 pulls in the front of the lens such that a standard step-up ring will jam it (imminent breakage!)
b) I use 77mm filters, all over the place, even on lenses with 52mm filter thread (this is the most "extreme" case; less than 9mm "stick out")
I used a lathe to cut a standard 67-77mm step -up ring such that the inner part had 69mm outer diameter. Then used this thing to elongate the step-up ring along the lens axis. Glue the part onto it.
Why:
a) The P900 pulls in the front of the lens such that a standard step-up ring will jam it (imminent breakage!)
b) I use 77mm filters, all over the place, even on lenses with 52mm filter thread (this is the most "extreme" case; less than 9mm "stick out")
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!