Thingiverse
Stepper Mounting Tab
von wd5gnr
3
Downloads
0
Likes
0
Makes
I needed a simple mount for a NEMA17 to a piece of 2020/2040 extrusion. I wound up with an OpenSCAD design that can configure a few different ways. I needed a 2mm thickness for a Titan extruder, and that's a little wobbly, so I added crude bracing which helps. If you do the right angle, you'll need supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
