Thingiverse
Strawberry Hide
by warmarine759
26
Downloads
33
Likes
0
Makes
a person wanted a hide for a gecko that was strawberry shaped. The bottom pops out for cleaning.
You need to glue the little tabs in
to get the leaves to fit either warm up the leaves with a heat gun (carefully) or use warm water to then press the leaves down warping them to fit on the berry
uses an M3 bolt to attach
You need to glue the little tabs in
to get the leaves to fit either warm up the leaves with a heat gun (carefully) or use warm water to then press the leaves down warping them to fit on the berry
uses an M3 bolt to attach
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
