Thingiverse
Strawberry Hide
von warmarine759
26
Downloads
33
Likes
0
Makes
a person wanted a hide for a gecko that was strawberry shaped. The bottom pops out for cleaning.
You need to glue the little tabs in
to get the leaves to fit either warm up the leaves with a heat gun (carefully) or use warm water to then press the leaves down warping them to fit on the berry
uses an M3 bolt to attach
You need to glue the little tabs in
to get the leaves to fit either warm up the leaves with a heat gun (carefully) or use warm water to then press the leaves down warping them to fit on the berry
uses an M3 bolt to attach
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!