MakerWorld
Garden
Go to Model
Strong stackable plant support
291
Downloads
85
Likes
242
Makes
A strong plantsupport, with the possibility to stack on itself. The legs can be pressed firmly in the hexagonal base.Depending on your printers tolerances you maybe need to glue them, to keep it all intact in case you´re planning to move the supports around several times. Width is approx 100x100mm and fits nice in smaller variants of pots. Prints with small supports in the holes for the legs. It is possible to print without, but the legs can be a bit tricky to get in then.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
