MakerWorld
Garden
Zum Modell
Strong stackable plant support
291
Downloads
85
Likes
242
Makes
A strong plantsupport, with the possibility to stack on itself. The legs can be pressed firmly in the hexagonal base.Depending on your printers tolerances you maybe need to glue them, to keep it all intact in case you´re planning to move the supports around several times. Width is approx 100x100mm and fits nice in smaller variants of pots. Prints with small supports in the holes for the legs. It is possible to print without, but the legs can be a bit tricky to get in then.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
