Thingiverse
Stronk tiny hook
von maschmitt
1
Downloads
2
Likes
0
Makes
Hook (with or without protrusion for a zip tie), for your semi-temporary cable routing needs.
- Inside diameter is 15 mm. Scale and mirror(!) to your liking.
- Print on the side. No supports.
- Originally designed for an M4 flathead screw with matching 4.3x12 washer.
- Countersunk washer was added later and works so well, I wish I had come up with it earlier.
- Robust design for ASA because I use them in full sunlight.
- Indestructible (I tried!) when printed in PLA with a bit of overextrusion.
- Inside diameter is 15 mm. Scale and mirror(!) to your liking.
- Print on the side. No supports.
- Originally designed for an M4 flathead screw with matching 4.3x12 washer.
- Countersunk washer was added later and works so well, I wish I had come up with it earlier.
- Robust design for ASA because I use them in full sunlight.
- Indestructible (I tried!) when printed in PLA with a bit of overextrusion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
