Stubby Screw Driver With Magnet

This is a stubby screwdriver for standard hex bits with magnets to hold the bits in place. This short profile allows you to get at any fastener. I used this on my car in an impossible to reach spot for any screwdriver or rachet wrench, this screwdriver worked perfectly and I was able to get enough torque to secure the bolt. The magnet version has room for 2 6mm x 2mm magnets that help keep your bit in place. I found 2 magnets to give just a bit extra holding power. The magnet is press fit in the bottom of the hex so there is no need to pause. Once the print is done simply attach the magnets to the end of a bit and insert the bit into the shaft and press the magnets into place. The magnets will be stuck in place and no amount of inserting and removing the hex bit will pull it from the press fit. If the fit is too tight or not tight enough scale the print +/- 2% at a time. There is a nonmagnet version. The fit on the bit should be just tight enough where it will not fall out on its own.