Sub pump cover

This is a cover for a sub pump. The lid as seen in the picture had a massive hole. The problem with this is if a snake or something somehow got near it, then it could just go in the pump. This keeps them from going in the hole but allows water to go in it.

I'm still working on this, but you can use what I got now. I need to strengthen the model because the model is about 0.5 mm thick. Which means there is a lot of flex in this.

Any case, I highly suggest using PETG. I think ABS will be OK too. I would stay away from PLA since it will break down as water goes over it. (In my experience, PLA likes to slowly break down. This in return would clog up your pump and force you to repair it or get a new one.)


As far as the size, that's just the max I can build on my mk3. I'm going to be making the other side soon.