Thingiverse
Sun and Sails
by Skyblue
27
Downloads
33
Likes
0
Makes
Faux stained glass-light catcher. Printed in ABS @.3mm.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
