Thingiverse
Sun and Sails
por Skyblue
27
Descargas
33
Likes
0
Makes
Faux stained glass-light catcher. Printed in ABS @.3mm.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
I used some acetone to glue pieces into recesses in frame.
PLA users could use white glue.
Note: My faux stained glass models are scaled for 8 x 8 platform.
If you re-scale, pieces might be too small to handle. Also if made smaller, you must ensure that your "glass" pieces are at least 2 layers thick after slicing. Frame prints upright, pieces print upside down, flip pieces over and insert into upright frame.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
