Thingiverse
Sun Ray Chakra
von bharbhar
13
Downloads
14
Likes
0
Makes
||ॐ||
This is a base and a cover for the starship coil frame found here: https://www.thingiverse.com/thing:506849.
The coil frame needs to be printed at 6cm diameter x 4cm height.
The base fits exactly outside the coil frame's bottom and inside the cover's inner radius to form a tight fit.
Wind the coil using a thin magnet wire. I have used #40 wire shown here. The wire needs to be thin enough to make 200 or more layers, but thick enough to feel tight on your fingers. It needs to be thin enough to not break the legs, but thick enough to make a tight wrap around them.
The full assembly including the coil is called the Sun Ray Chakra. The end result is a hand held starship coil.
Included are STL files and OpenScad files for your modification.
||ॐ नमः शिवाय||
This is a base and a cover for the starship coil frame found here: https://www.thingiverse.com/thing:506849.
The coil frame needs to be printed at 6cm diameter x 4cm height.
The base fits exactly outside the coil frame's bottom and inside the cover's inner radius to form a tight fit.
Wind the coil using a thin magnet wire. I have used #40 wire shown here. The wire needs to be thin enough to make 200 or more layers, but thick enough to feel tight on your fingers. It needs to be thin enough to not break the legs, but thick enough to make a tight wrap around them.
The full assembly including the coil is called the Sun Ray Chakra. The end result is a hand held starship coil.
Included are STL files and OpenScad files for your modification.
||ॐ नमः शिवाय||
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
