Thingiverse
Sunflower - Springy Flower Collection
por lglauberman
34
Descargas
104
Likes
0
Makes
This is a Sunflower that is compatible with my springy flower collection found here: https://www.thingiverse.com/thing:6861891
The springy dirt snaps into the planter, the stem screws into the springy dirt, the sunflower slides onto the stem and the floret (center) snaps into the flower. If you do not plan on removing the flower from the stem a drop of epoxy can be added to the tip of the stem.
Do not scale down or the threads will not work! Print at a fine layer height such as .16mm.
I recommend the springy dirt be made out of ABS with 3 wall loops if possible or it might sag over time.
No supports are required.
The models shown were printed with ABS using a .16mm resolution.
Please like and upload a make!
The springy dirt snaps into the planter, the stem screws into the springy dirt, the sunflower slides onto the stem and the floret (center) snaps into the flower. If you do not plan on removing the flower from the stem a drop of epoxy can be added to the tip of the stem.
Do not scale down or the threads will not work! Print at a fine layer height such as .16mm.
I recommend the springy dirt be made out of ABS with 3 wall loops if possible or it might sag over time.
No supports are required.
The models shown were printed with ABS using a .16mm resolution.
Please like and upload a make!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
