Thingiverse
Sunlu spool support
von PrintyPaws
4
Downloads
2
Likes
0
Makes
This is a hub adapter to fit a Vauxhall Corsa C Rear drum bearing into a sunlu spool, on an Anet A8 Spool holder, for a totally, dead center, smooth rolling spool!
Full bearing width is not necessary for this application, and a waste of filament.
Parts required pressing into place with a bearing press. 40% cubic infill (amazingly) withstood the pressures with a tiny amount of crackling noise going in. This will not come off without breaking something!
Seriously, unless you happen to have a Vauxhall Corsa C Rear wheel bearing lying around (like I did), don't print this!
Full bearing width is not necessary for this application, and a waste of filament.
Parts required pressing into place with a bearing press. 40% cubic infill (amazingly) withstood the pressures with a tiny amount of crackling noise going in. This will not come off without breaking something!
Seriously, unless you happen to have a Vauxhall Corsa C Rear wheel bearing lying around (like I did), don't print this!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
