MakerWorld
Vehicles
Zum Modell
Super Glider
2.3k
Downloads
469
Likes
1.4k
Makes
the final version of my glider model, which is very easy to print. all it takes is one print, a little editing, and it's ready to fly! printed in pieceRecommended print parameters:3 walls20% infilMaterial PET-G(can use PLA but PLA is brittle so there is a high chance the plane will crack)Pre-flight instructions:list of needs:hair dryer, screw and nut M4, some pens or markers, glue for plasticuse a hair dryer to adjust the wings as shown in the photo. under the wings with markers so that the wings are V-shaped:the center of gravity of the aircraft needs to be adjusted for the best result. screw a screw with a diameter of M4 and a length as required into the front hole. according to the photo:glue the holder in place of the bottom groove for easy throwingadjust the tail flaps for better flight enjoy flying!
soukup273 veröffentlicht auch auf
71 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
