Thingiverse
Super Tiny Test Piece
door zx82net
44
Downloads
34
Likes
3
Makes
I made this super small test piece for testing different settings, it is small enough to print multiple units on the bed in series rather than parallel.
It includes steep overhangs and a bridge. It works well as a test for layer adhesion, slide your thumb between the base and the overhang, as shown in the photo. If you can snap it away from the base by doing that, you need to work on your layer adhesion!
It includes steep overhangs and a bridge. It works well as a test for layer adhesion, slide your thumb between the base and the overhang, as shown in the photo. If you can snap it away from the base by doing that, you need to work on your layer adhesion!
zx82net publiceert ook op
17 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
