Supercar

Supercar
Not my design
https://www.thingiverse.com/thing:5334072
having found this on thingiverse ,
wanted to print it
so i corrected a few errors
one being it couldn't be printed as it was as it would be full of uncured resin,
so chopped it to 4 pieces
put drain holes
so managed to print it at 150%
CTB file attached for elegoo mars 3
Hopefully if your printer is different you can see the layout
no supports needed for resin print
for PLA you will have to check what supports are needed
I am chuffed with my print

Final output = 160mm
ill put a pic up when its painted


Later i may remove the canopy design the inner area and print a clear canopy
(when I've got a week spare)

I've notice there should only be 1 pod on the end of the wings
Presumable the wings would be retractable so the pod as been put in both positions
I have sanded the inner pod away with no detriment to the model

(by printing straight on the print plate, there will be a fatted edge to