Thingiverse
Superellipsoid
von problemate
1
Downloads
2
Likes
0
Makes
As I wanted to test the printer with curved surfaces, I tried to make a surface with which I was very familiar but it was uncommon.
So I built a small program in python that triangulated many points on the surface, demanding that the distance from the center to the surface of each triangle be less than the precision of the printer.
After some tests, here is the result.
So I built a small program in python that triangulated many points on the surface, demanding that the distance from the center to the surface of each triangle be less than the precision of the printer.
After some tests, here is the result.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!