Superfast Modern Drawer Pull (vase mode)

How to make dozens of full size 3d printed drawer pulls in a couple of hours ? Well, my answer is a super simple design combined with vase mode printing.The pull is 100mm high so yo can scale it up easily to match your needs. Actually for an adult hand, you can keep 100% in X and Y and adjust to 80% in Z. For a single finger pull, you can adjust Z to 25%.Print SettingsPrinter:Prusa I3, Tarantula, CoreXY, FLSun Delta.Rafts: NoSupports:NoResolution: Any (optimized for 0.4mm nozzle)Infill:0% Notes: Print in vase mode. Set your nozzle to the max temperature allowed by your filament manufacturer.Post-Printing =============How to install ?Just glue the drawer pull on the edge of the drawer or door. pay attention to avoid squeeze out. I have good results with 5mn epoxy glue. Category: Organization