Thingiverse
Support Camera for Raspberry
por branda92
1
Descargas
0
Likes
0
Makes
I created this drawing to apply a USB camera to my raspberry with Octoprint.
I removed the electronics from the original Camera case, and inserted it into the printed one. I then fixed it using the printed support, in the two screws that secure the Y axis motor.
I replaced the original screws with M3x20 screws.
I also used the original screws to secure the electronics in the new case.
I also used small screws to secure the rear cap.
https://www.amazon.it/dp/B07N39RPLK/ref=cm_sw_r_cp_api_glt_i_FJ7TN5V8WH65KXE7WK0K?_encoding=UTF8&psc=1
I removed the electronics from the original Camera case, and inserted it into the printed one. I then fixed it using the printed support, in the two screws that secure the Y axis motor.
I replaced the original screws with M3x20 screws.
I also used the original screws to secure the electronics in the new case.
I also used small screws to secure the rear cap.
https://www.amazon.it/dp/B07N39RPLK/ref=cm_sw_r_cp_api_glt_i_FJ7TN5V8WH65KXE7WK0K?_encoding=UTF8&psc=1
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
