Thingiverse
Support Material Idea(Skeinforge Plugin Needed)
door mctrivia
1
Downloads
7
Likes
0
Makes
What do you do if you have a crazy large overhang and you can't just flip the model over? Try this.
Bad Table is impossible to print on a makerbot without flipping it over and printing upside down. Good table though can be. You then just break off the single line think support material and you have your table.
Bad Table is impossible to print on a makerbot without flipping it over and printing upside down. Good table though can be. You then just break off the single line think support material and you have your table.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
