support test

Are you planning to print a large model that requires support? Are you worrying about support failures? Then simply print this support test. It uses only 8 grams of filament, takes only 26 minutes to print (not including calibration) and tests all 8 automatic support types. You could even use it to test custom support settings. To get a result, simply see which cube has the easiest to remove support and the best bottom surface. I will release print profiles for different surface types soon and if you think this model needs any other updates, just comment.Key:Tree strongTree defaultNormal gridTree hybridTree slimNormal snugNormal defaultTree organicBoost MeI am saving to get an AMS lite so it really helps.