Support Test V2

**__Ko-Fi:__** [https://ko-fi.com/juliettaexpress](https://ko-fi.com/juliettaexpress)

---

Literally just my car test model flipped upside down (see remix source). Use it to calibrate supports. Overhang is 1mm thick and long enough that sagging should readily occur.

For quickest results with the least amount of filament used, print with zero infill, one perimeter, and only enough shells to make the 1mm stretch fully solid (three shells for 0.2mm layer heights, two shells for 0.25 layer heights). Should print just fine with those settings.