Thingiverse
Supportless phonestand
por Zendreti
27
Descargas
35
Likes
0
Makes
Yet another phonestand, wanted one that could print without support.
Made this for my (now X-)wife, Did fit her Sony X Performance nicely.
Phone opening is just below 10mm . (9,959mm if i remember correctly)
72mm wide. Prints on side without the need for support.
Extra high to accommodate usb charging cable.
Use a raft to avoid warping
Made this for my (now X-)wife, Did fit her Sony X Performance nicely.
Phone opening is just below 10mm . (9,959mm if i remember correctly)
72mm wide. Prints on side without the need for support.
Extra high to accommodate usb charging cable.
Use a raft to avoid warping
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!