Thingiverse
Surface Book Stand
von johnime
42
Downloads
40
Likes
0
Makes
This is a Microsoft Surface Book (13") laptop stand. The angle is 30 degrees.
I struggled to find a stand that fits my surface book well, the laptop is back heavy. Some are too small, others are too big for my printer. I ended up creating this, my first design.
Dimension: Laptop surface angled face sits 222mm, length 216mm, raised height 136mm.
Bridge width: 235mm.
Printed on my Ender 3 Pro with PLA, need to set skirt off and rotate slightly to fit within the printable area.
I struggled to find a stand that fits my surface book well, the laptop is back heavy. Some are too small, others are too big for my printer. I ended up creating this, my first design.
Dimension: Laptop surface angled face sits 222mm, length 216mm, raised height 136mm.
Bridge width: 235mm.
Printed on my Ender 3 Pro with PLA, need to set skirt off and rotate slightly to fit within the printable area.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
