Thingiverse
Sushicutter
von Waessman
15
Downloads
16
Likes
0
Makes
Picture with sushi is not the one from files.
Offset to inner part is 0.2 mm each side.
Adapted for FDM (if your measures is correct on outer, the inner will be smaller and this you dont have to worry about.
Prints/files orientation is already optimal, you just need to slice it....
Happy printing
Offset to inner part is 0.2 mm each side.
Adapted for FDM (if your measures is correct on outer, the inner will be smaller and this you dont have to worry about.
Prints/files orientation is already optimal, you just need to slice it....
Happy printing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!