Switch Extension

I got tired of reaching under my desk to flip the switch for my power strip, so I create this switch extender. This consists of two parts, a lever with two hooks for gluing to the power strip plug, and the switch part. The switch is designed to pivot on a #10 wood screw (that's what I had available), however, thinner screws should work just fine so long as the head is not thinner than .207 inches. I used hemp rope (again what I had available) to link the two loops from the lever to the switch. You should be able to use any string/twine/fishing line you have available. These should be as tight as you can make them.

The parts themselves are printed at .2mm layer height with PLA.