Thingiverse
Switch Handle
door Tel0ss
0
Downloads
4
Likes
0
Makes
This is a quick handle for the PDS2-330 disconnect switch.
https://www.c3controls.com/configurator/non-fused-disconnect-switches/#
s103 is scaled to 103%
The ones we use in the field or for installation are not always easy to use or test before the entire systems are built around (ie long shaft) the switch.
This can be kept in your tool box, or used as your primary handle if you are just using a salvaged switch for anything.
The PINK picture is V1, see the zip, as the alignment isnt as nice.
the yellow screenshot (BROWN PRINT) is the final V2 version.
Hex is 8.8mm inscribed. inner recess is 17mm but may vary based on printer, try scaling from 97-104 if its not quite right, you should have a pretty good idea where your printer sits.
Soildworks file could be made available if in demand, or if a minor size tweak is needed.
https://www.c3controls.com/configurator/non-fused-disconnect-switches/#
s103 is scaled to 103%
The ones we use in the field or for installation are not always easy to use or test before the entire systems are built around (ie long shaft) the switch.
This can be kept in your tool box, or used as your primary handle if you are just using a salvaged switch for anything.
The PINK picture is V1, see the zip, as the alignment isnt as nice.
the yellow screenshot (BROWN PRINT) is the final V2 version.
Hex is 8.8mm inscribed. inner recess is 17mm but may vary based on printer, try scaling from 97-104 if its not quite right, you should have a pretty good idea where your printer sits.
Soildworks file could be made available if in demand, or if a minor size tweak is needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!