Thingiverse
Switch Holder
von PartayPat
4
Downloads
3
Likes
0
Makes
A holder for a toggle switch that clips nicely between to two lower 2020 extrusions of my kossel XL. It's for switching my LED strips on and off which I am retaining using this diffuser I made as part of my pringter lighting project. (https://www.thingiverse.com/thing:3966326)
There is a hole on the back big enough to stick a 2 way molex crimpy thingy through. The switch just push fits into the holder and the holder just pushes in between the bars. The holder can be positioned by sliding back and forth with a bit of force.
Simple, does the job. I should probably tidy up that birds nest of wires at some point though...
There is a hole on the back big enough to stick a 2 way molex crimpy thingy through. The switch just push fits into the holder and the holder just pushes in between the bars. The holder can be positioned by sliding back and forth with a bit of force.
Simple, does the job. I should probably tidy up that birds nest of wires at some point though...
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
